Optoma HD161X Guide de l'utilisateur télécharger pdf (Page 58)

Appendices

Lamp Replacing Procedure:

1. Switch o the power to the projector by pressing the Power

button.

2. Allow the projector to cool down at least 30 minutes.

3. Disconnect the power cord.

4. Remove the single screw on the lamp compartment cover.

5. Remove the lamp compartment cover.

6. Remove the two screws from the lamp module.

Lift the module handle up.

7. Pull rmly on the module handle to remove the lamp

module.

To replace the lamp module, reverse the previous steps. While

installing, align the lamp module with the connector and ensure

it is level to avoid damage.

8. Turn on the projector and do "Lamp Reset" after the lamp

module is replaced.

Lamp Reset: (i)Press "Menu" -> (ii)Select "System" -> (iii)

Select "Lamp Settings" ->(iv)Select "Lamp Reset" -> (v)

Select "Yes".

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 84 85

Pas de commentaire

Optoma HD161X Guide de l'utilisateur Page 58