Optoma W401 Manuel d'utilisateur télécharger pdf (Page 17)

English

Installation

POWER

SOURCE

Powering On/Off the Projector

Turn on the projec- 

tor rst and then

select the signal

sources.

Powering On the Projector

1. Remove the lens cap. 

2. Securely connect the power cord and signal cable. When

connected, the ON/STANDBY LED will turn Amber.

3. Turn on the lamp by pressing “ ” button either on the top of

the projector or on the remote. The ON/STANDBY LED will

now turn Green. 

The startup screen will display in approximately 10 seconds.

The rst time you use the projector, you will be asked to

select the preferred language and power saving mode.

4. Turn on and connect the source that you want to display

on the screen (computer, notebook, video player, etc). The

projector will detect the source automatically. If not, push

menu button and go to “OPTIONS”.

Make sure that the “Source Lock” has been set to “Off”.

If you connect multiple sources at the same time, press the

“SOURCE” button on the control panel or direct source keys

on the remote control to switch between inputs.

POWER

Lens Cap

Power

When Power mode 

(Standby) is set

to Eco (<0.5W),

the VGA output,

Audio pass-through

and RJ45 will be

deactivated when

the projector is in

standby.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 78 79

Pas de commentaire

Optoma W401 Manuel d'utilisateur Page 17