Optoma WHD200 Manuel d'utilisateur télécharger pdf (Page 22)

4. Troubleshooting

Problem Solution

The WHD200 power

indicator LED doesn't

light up.

 Check if the power plugs of WHD200T/WHD200R are properly

inserted into a functioning power outlet.

No video is displayed

on your TV screen.

 Verify that the proper cables have been selected and installed

between the WHD200T (transmitter) input and your High-Definition

device output.

 On your TV side (connected to the WHD200R), select the HDMI as

input source.

 Verify the POWER LED and SOURCE LED indicator of WHD200.

Power LED Flashing in Blue

OSD displayed: (4 levels looping)

* Ensure the transmission range between the transmitter and the

receiver is NOT over 66 feet (LOS-line of sight) transmission distance.

* Try to move the transmitter closer to the receiver.

POWER LED in Solid Blue + Slow and Flashing SOURCE LED

OSD displayed :

* Ensure your video resolution and frame rate is recognized/ supported

and within the transmission range.

*Connect the source device to your TV to check and modify the video

format compatibility.

*Check if your video resolution with HDMI input from your device is set

among 1080p, 1080i, 720p, 576p, or 480p. Please refer Chapter 5 for

the detail supported Resolution.

POWER LED in Solid Blue STATUS LED Flash Quickly

OSD displayed :

* Ensure the proper cables are connected between the transmitter and

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Optoma WHD200 Manuel d'utilisateur Page 22